Regarding the specifications of auto bed leveling

Bambu Lab X Series General discussions
1

I would like to ask a question to those who use X1C.

I believe that when the bed leveling is checked before printing, the order is center homing, 5-point tramming check, bed leveling, X,Y axis sweeping check, and then printing.
There seems to be a pattern of shifting to bed leveling in the middle of this tramming, and another pattern of skipping bed leveling and entering X,Y axis sweeping as soon as the 5-point tramming is completed.

It seems that if the bed tramming is proper, I can skip bed leveling and move on to printing, is that how you guys are doing it?
Or is it just remembering the result of the previous bed leveling?
The printer firmware is 01.05.02.00.

Thank you in advance.

2

On a cold start, it’ll do the full bed level check, I think 25 points in a 5x5 matrix. If you don’t power it down and run another print, I think it does a 5 point check (center and 4 corners) and if it likes that, it doesn’t do any additional checking. If you know you haven’t pushed hard on the build plate since the last print, it’s probably unchanged from the last leveling check and you can skip auto-level after doing it once (and not powering down) and it won’t do any checking at all.