If I have my X1 Carbon selected in the preparation tab, I only see the Orca Slice version of the calibration. There is no way to manage the K-values at all. To access the standard Bambu Lab calibration tab, I have to switch to the H2D in the preparation tab while still being connected to my X1 Carbon in the device tab.
This is a rather awkward workflow.
The situation is the same if I install Studio on a fresh system where I haven’t logged in yet.
It might be because I’m using developer mode to access some experimental settings, as you need developer mode enabled to see the Orca-style calibration.
Regardless, I should still be able to manage my K-values properly. It’s quite illogical to have to tinker with a different printer just to access the correct settings.