Resume failed prints with the AMS lite

I seem to have a lot of failed print jobs because of extruder not working correctly (there was a message TLDR), tangled filament, etc. I thought this printer would allow the changing of filament (for say like run out) but it’s like the machine won’t do anything after the print fails it lets me look at the error and then I get the option of cancel the job or try again but you can’t change the filament (the AMS lite does nothing during this time).

What I want to know is about failed prints and being able to change the filament either to another roll on the AMS or by placing another roll on the AMS in the same location. I searched the wiki and nothing about resuming failed prints with an AMS lite, just showed me all the other things that can go wrong with this printer.

You can move the hotend over to cut the filament & unload it.
When you reload you will have to push it all the way to the hotend.
Then hit retry to purge.

Thank you! That worked, I thought it was going to be some button pushing and menu searching but all it took was a little bit of manual maneuvering. Would not have guessed.