Well it is a partnership that was signed off so clearly there is no issue. They would have required the 40W revo heater if there was an issue but allowed the 60W and signed off on it
It’s fine It’s only going to heat up so much it’s software control.
That wattage is just the maximum output that it can do.
You do have a point, still would like to know the specs for the board though.
Ordered one for good measure 
@masc2279 is it the same height as the original hotend or did you have to modify the nozzle wiper?
Completely stock use no mods needed
The only thing i chaned since installing it is running temp towers and Max flow rate tests and i set these now i only mainly print in PETG so only ran test for PETG.
Added 10 deg to PETG Settings. - Bambu Had Set 255 i moved it to 265
0.4HF recomended flow 24 i got and set 26
0.6HF recomended flow 31 i got and set 35
0.8HF recomneded flow 38 I got and set 39
So the flows on the Revo Page for High flow were spot on and for me a but conservative bit, that might be becouse of the added temp.
Thanks. I mainly use Prusament when printing PETG and figured I’ll have to do some calibration prints for the filaments I use.
How did you get the hotend so early anyway? Mine’s on backorder till (late) March or something like that.
I had a friend who told me when it was going live on the site for ordering and i was one of the first.to get my orders in. Granted mine had a Delivery of Jan 2nd but it was a week and a half later when it arived.
Dumb comment. A 1000W heating element would also be ‘software control’. That doesn’t mean the power supply, wiring, connectors, and switching elements are capable of driving a 1000W heater.
1 Like
Oh one last thing if you did not notice in the write up you will need a hot end fan this is the only part not included in the Panda Revo Kit. Yes you can re use the one from the current nozzle but i personally like having backups so ordered new fans just for the Panda Revo.
I have a couple of spare hotend assemblies. But thanks for pointing out, I’ll probably order a spare fan with my next order from bambu just in case.
Where did you buy the kit?
I can’t find anything about it, even on Aliexpress 
1 Like
Did you ever get a temperature error while running the max flow test? The stock heater is too weak for good flow with CHT hot ends, I am resorting to running dual heaters to compensate.
These are 60W heaters not the 45W stock heaters.
Yes I’m aware, thats why I’m asking. I want to know if they can keep up with flow and avoid the errors. Also can we see a photo of the heating element on its own or at least with the silicone sock removed.
It looks near identical to the 45W revo. And no, I haven’t ran into that issue you mentioned, not sure about OP.
I have not gotten any errors or issues as of yet and those printers print non stop. Nor any issues when printing the test. Now as soon as i saw issues on the test i stopped could i have seen something if i let it go on. who knows but its been flawless so far
Would love to see you run a max flow test with a good PLA so I can compare to the Ali CHT nozzles as the Panda is quite pricey.
On my next order i will order some PLA i just dont print with it only for the support interface layer and i am low on it anyways.