Safety Timer G Code?

Bambu Lab Software Bambu Studio
1

Does anyone know if by chance the M86 safety timer g code that’s found on the Prusa MK3S exists for the Bambu Lab printers?

I print a lot of items where I pause to insert magnets during the print, and for the MK3S I use M86 S0 to turn off the safety time to make sure the bed stay heated until I can get to the print to insert the magnets. Then I return the safety timer to 10 minutes with M86 S600. I also set the nozzle to zero and then reset to the print temp before resuming.

I haven’t tried a print yet to see if there’s a timeout for the for the bed and/or nozzle, so just wondering if anyone has experience with this.

Thanks!

2

My experience is that on a pause, the nozzle heater shuts off but the bed stays on - this is desirable as a cooling bed can cause the print to detach.

1 Like