I’ve sent a few different prints to my printer using Bambu Studio. I didn’t have any problems till recently. I sent a print, the print was successful. Now, any time I send another print to the printer, it prints that same print.
Bambu Studio shows the new print and print times and everything being sent, but when the print starts, it’s the old, not the new. There are no error messages and I can control the printer as normal.
Huh, probably has something to do with the SD Card being “write protected” though how that happened I have zero idea. I’ve tried a few different solutions but the drive remains “protected”. Any ideas?
This could be because the controller on the card has detected some kind of media error and is about to die, or the write protect bit might have glitched from a 0 to a 1 due to current leakage, SEUs, aliens… I’ve seen it before in the early days of flash memory but it is rare. My money would be on pending media failure
I haven’t had my P1S a full 4 months and out of no where it is doing the same thing. I dont think I should have to have sevral sd cards laying around because of faulty or cheap sd cards. Ive printed a load of stuff with 0 problems and love it. But I went to print yesterday and it said i didn’t have an sd card. Anyone know how to fix this?