Hello everyone,
I found this small black plastic piece near my Bambu P1P and I’m trying to figure out what it is or where it came from. I have an AMS sitting on top of the printer, and it seems to be printing fine so far.
Does anyone recognize this piece or know where I should check on the printer?
That material goes by a couple different names:
https://www.amazon.com/s?k=continuous+grommet+edging
On the P1P, it is placed on the sheet metal behind the printed head at the back of the printer. It is intended to prevent chafing of the PTFE when the hotend moves to the back.
This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.
