Solution: The build plate is not placed properly

[Olias]

@Abnerdoubla

I used a printed extension part for another project which is nearly the perfect size to fit under the bed in this position. I

This sounds like a good example of creative ingenuity. Can you share the model that you are using for this purpose? I’m sure other’s would benefit.

[Abnerdoubla]

You bet. I was printing some boat accessories and found this to be near perfect in height. Not my model, (all credit goes to Manuelo72 the OP on Thingaverse). There is a slight gap so if that imperfection is bothersome, with the unit off, I just turn the zscrews to take out the slack and tap away. Link below:

Scotty extender by manuelo72