Yesterday, I tried to remove the LED bar, but BL used too much glue to secure it to the connector housing on the LED pcb. I ripped out the two wires 
the result of that… I shorted the two wires 
I know, its my fault, the printer was on 
Now, I cant turn on/off the LEDs anymore, and the brightness is very low - its more a glow. I measured the voltage. Without the LED I got the 5V, but as soon I connect the LEDs, the voltage drops to 3.4V.
I think something is damaged on the AP Board. Does anyone know, if BL sell this board separately, that I can replace it (If its not too expensive - but what I am afraid of)?
