I just ordered this filament. I searched the forum and I’ve seenpeople mostly seem to be having problems with it. I want to use Polymaker Panchroma Matte PLA (and Polymaker PETG later) with it and was wondering if the stock settings in Bambu Studio for Support for PLA/PETG work for you. I will use it only as support interface and was planning to use the left nozzle for support interface and right nozzle for model and support base.
fot petg it works better, not sure about pla.
Interesting, PETG seems to need higher temperatures and the temperature gap between PLA and Support is smaller than PETG and Supprt. I guess that’s not a factor?