I have printed a model that i have many times with same settings as before… since new update the support interface is not the same as before and my prints in abs and petg all faill when it comes to the support
that confirms why there is alot of low ratings are going on in makerworld, as from what i’ve been reading about Bambu studio V2, there is a lot of issues and more with V1 print profiles.
although the latest V1 version has issues with support too (supports harder to remove) rather than the one before it.
i’m holding off any new uploads because i started getting complaints (low ratings) about issues in the prints, and i’m pretty sure it will be a process to update all 70 profiles i have.