i recently put up a model thats an accessory for the a1 series. however people told me it didnt fit and gave me bad ratings even after i tried editing once and successfully tested it on my printer so i took it off MW.
after switching a lot of settings in the slicer, i feel like i have it right. i successfully tried it out on my printer and put up the model on MW.
i’m still not sure if it will work for everyone else like before (which i still dont know why) so i would like to request a couple of people to test it out and let me know the results.
the model is: extruder gear for a1 series - Free 3D Print Model - MakerWorld