You want to adjust the z offset if you are using the textured plate.
At this to your start gcode:
;===== for Textured PEI Plate, High Temp Plate and Wham Bam Plate ===============
;curr_bed_type={curr_bed_type}
{if curr_bed_type==“Textured PEI Plate”}
G29.1 Z-0.04 ;squish of -0.04mm for Textured PEI Plate
{elsif curr_bed_type==“High Temp Plate”}
G29.1 Z0.03 ;raise of 0.03mm for High Temp or Wham Bam Plate
{endif}