The current build plate is not the same as in G-code

[newsletter]

This is interessting. Please see also my message

Changing type of build plate does not change g-code

I generated a new project and wanted to use the same plate, material as in the previous. I made the mistake not to check the type of build plate selected. It was the default and not the one I wanted. (Mea culpa.) After sending to the printer, the printer complained, that the build plate in the printer was not the same as in the g-code. Very good! But I did not want to use an other plate. So I aborted the print, went back to studio, changed here the type of the plate, sliced again and sended it…

I am not sure if studio send wrong g-code or if there was some other reason.

The problem is: the error message does not say what plate was expected due to the g-code and what type of build plate was recognized.

I recently got also this message while I was sure that the settings in studio were correct from starting the project and the build plate also. So I selected “continue”. I suspected that I had perhaps put too much glue on the plate and that this has irritated the printer.

And now I found your message