The H2D Vision Encoder plate

Bambu Lab H2 Series
1

I purchased the H2x Vision Encoder plate, which is not a standard (for the H2D), and went to run the calibration. The plate is smaller than the rest of the plates, and doesn’t sit on the hotbed like it should, and the scientist in me doesn’t see it can be accurate if it isn’t placed right?

Should the plate be the same size as the rest of the H2D plates? If not, how do I insure it’s installed right before I start the process?

2

The calibration plate should still fit with the [Rear] tabs against the [Plate Locators] on the heat bed platform.

photo attached for reference

Although it is smaller, it’s smaller in width only which the locating tabs should still function just like the regular build plates.

Vision Encoder Plate
Vision Encoder Plate937×456 67 KB

3

I’m curious about this. I have the H2C and it fits just like all the other build plates. My issue is that it keeps telling me it’s not position correctly and may collide with the Vortek rack. I’m 100% sure it’s exactly where it needs to be, so I skipped the error and told it to continue. I’m just not sure why it was telling me that.