Hello, nice to meet you all. new guy here. I just bought my first 3D Printer, P1S. I have been used it daily to try out and play some printing that I want to tried. But, I found that when I print some small gap or small connectting or anything that too small, it will left end thread-like remaining. Eventhough, so far, what I print is never a problem, but sometime I must cut or clean the thread-like remaining. Even it can be trouble like th right picture, it can’t slide because of that, I must cut it and it can slide smoothly to other obect.
is there any setting in Bambu studio I should change or concern about it?
