Anyone else having top layer issues with H2D with default settings? Same settings between x1c and h2d. H2D significantly worse top layer even after manual flow dynamics and flow rate calculation.
Auto flow dynamics doesnt seem to work well yet.
I already know the many ways to bandaid this but just curious if anyone else is having this issue out of the box
2 Likes
Honestly, I doen’t see any differents, because only the middle sample is in focus.
1 Like
Mine has been really good. Haven’t even considered any manual calibration. Its been largely click and go. I will say that I noticed more layer quality issues initially, but after about 20 hours of printing the quality issues (mostly layer stacking) cleared up. Now it printing better than the printer it replaced.
1 Like
Same boat. Blown away at the quality.
I’m using the stock 0.4mm with stock slicer settings. Can’t imagine what 0.2mm with lower layer height will look like.
1 Like