TPU 95a HF from Bambu labs, printed in the Bambu a1 with a harder steel nozzle, any idea why it looks like this? Supports printed like candy canes.
I have dried the filament, and reprinted it and found out that decreasing the speed 50% has helped the quality.
Sorry thought 95A was the new one! I’ve printed a few things with it, but not models like yours. Even so, it looked much better than that.
Everyone is going to ask if you dried it.
Set volumetric speed to 1.5mm3. Helps me a lot. Might be overkill slow but that works the best for me. 12mm3 is way too fast for TPU to get good quality
