Hey all! So I’ve started to notice bed adhesion issues lately. I’ve exclusively been peinting with PLA on the provided textured PEI build plate. To give some background, I’ve been 3D printing for about 3 years. I started with an Ender 3 Pro, now own an X1C and recently purchased the A1. I run a tin…

I dont know what are you talking about, the printer works fine! [photo_2024-01-18_16-46-51] [photo_2024-01-18_23-09-12]

Woah!!! That’s terrible!! Glad I’m not going insane then. I could dial in my Ender sooo well. I feel trapped without bed knobs lol

Surprised seeing that. Did you try to run bed leveling in the printers settings. When doing bed leveling during calibration, it will run a finer grid and fine-tune the bed leveling done on every print. I had something like that happening when I got the printer. My problem was that the build plate w…

Oh yes absolutely everything checks out in these regards. Look at the pictures closely and you will see the build plate is positioned properly. I have run through a recal with no change. Auto bed leveling usually can’t deal with severe warps unfortunately. The software can typically handle small dev…

[image] Maybe bad bed Leveling is causing the nozzle kicks and bad adhesion? Bambu Lab A1 Series I found the bed leveling Gcode at the wiki and i saw that my bed was bad leveling. So i follow the instructions and manual leveling the bed, im going to try recalibrate everyt…

I´ve improve the quality of first layer, but found some inconsistence on some points of the bed. I dont know if its because bad manufacturing, dirty print plate, or bad consistence of filament flow. I ran every test and manual calibration, and im starting with regular pieces to rate the process. M…

Warped bed on my A1?

Bambu Lab A Series

Neiljt January 19, 2024, 12:55pm 6

Any use ?