This is what I’m getting with printing BL CF on my X1C. Any thoughts? Default BS settings for BL CF filament.
Have you dried the filament before printing?
Yes… I just printed the same part with 3DXtech CF and get the same mess. It’s very frustrating. Dried both prior to printing. I print the same part on my P1P and it’s clean.
I was able to calm some of these issues by increasing the retract settings but it was not the solution.
You’re just not drying the filament enough. 70-80C for at least 6-8 hours. Best to just do it overnight though!
1 Like