When printing, the walls of the model shift outward P1S

Bambu Lab P1 Series General Discussions
1

Hello.

When printing, the walls of the model shift outward (an example is provided in the attached photograph). It prints evenly from the table, but at the top, where there are crossbars on the model, the right and left alt shift outward by approximately 0.2 mm. The thickness of the wall itself remains unchanged; it just seems to shift

wall1
wall11860×1240 135 KB

example
example728×752 34.2 KB

2

i am having the same type of issue on a1 mini, specifically when the printer reaches a large top surface, for example the botton of a container, but i haven’t figured it out yet, and i think i am gonna contact customer support