Where did Lidar 1st Layer Inspection go?

Bambu Lab X1 Series
1

Hi there,

I am pretty new to the Bambu world. When I did my first prints (from the internal drive), I saw the Lidar First Layer inspection and the littel shape in the bottom left corner.

In my own prints (created with Bambu slicer) neither the little filament flow calibration area shows nor will the first layer be Lidar inspected.

EDIT: I see that the system presets are set to P1P. The list only shows P1P presets. Where can I find the presets for the Lab X1?

Best and happy printing,

Armin

3

Ok, found the solution. It seems that on initial setup of the Bambu Slicer I must have chosen the wrong printer thus the missing presets. You can re-run the setup wizard (through the “Help” menu on Mac version), then all is well.

I leave this here for people that are stuck with the same error.

3 Likes