I’m no expert on the matter, mine hasn’t arrived yet and I have no prior experience with lasers.
Reading through the cleaning guide though it seems rather time intensive: H2D Regular cleaning and maintenance recommendations | Bambu Lab Wiki
I’ve also read many comments from laser enthusiasts that state how stuck on the grime is when doing laser work, so it seems to require some elbow grease to really get it off.
I’m quite adept at cleaning but I’m also hesitant to mess up my 3d printing capability so I’m going to wait a bit to see how this all shakes out in a few months after people get a good amount of time out of the laser version before I reconsider firing mine up. My personal preference of usages was 3d printing and then blade cutting, but I’ll take a “free” laser cutter out of it.