Won't print generic filaments

[sundance4]

Is BL slowly trying to screw us and limit the filament we can use to only their filaments?

Recently I have been having problems with extruder clogged and another error I don’t remember, printing with generic filament. I tell it to go ahead and continue the print and it fails a short time again. If I switch to BL filament the print goes just fine and finishes. Is BL making us use their filament?? If not any ideas what is going on? The model is from Makerworld and I am printing on an A1.

[Cypherous]

@sundance4

Is BL making us use their filament?? If not any ideas what is going on? The model is from Makerworld and I am printing on an A1.

Depends, not all filaments can use the bambu default profile, i doubt there is anything bambu is doing

[sundance4]

It was filament I have been using for a while and they provide a profile for, Overture. I hope you are right.

[flabbyorca]

You might want to check if your nozzle is latched on properly.

I had similar issues until I realised that I had on occasion improperly latched on the hot end nozzly portion. Perhaps it’s the same case in your instance?