X1-Carbon did NOT Print true to size

[dc3D]

Hi,

same topic on my thread:

X / y dimensions of prints differ

Hi, Thanks! I am used to +/- 0,05 on 100mm on Anycubic i3 mega and Vyper after estep calibration for PLA. I admit, we are looking at completely different printing speeds of course… I will try X/Y compensation, but that will correct both equally in x and y, right?? So the difference between x and y accuracy will stay.

I worked with the suggested X/Y compensation, but did not get the results I was hoping for.
The outer most contour is enlarged/reduced in size, but any structure on the inside just stays the same.

Only thing that helps is set x/y scale before each print. z does not need correction for me.

For ABS i set it to 101% for x and y and get a perfect size.