I recently switched to a newer firmware with my X1C, and I noticed a couple of things that I have found with this new firmware version:
- AMS goes into full “error” mode whenever the bed levelling starts (red lights).
- AMS does not want to retract after print and thinks the filament is “external” or “clogged”. This is not the case, the filament flows fine.
- AMS having “connection issues”, despite not having this before the update and nothing has been changed hardware side.
- A couple of failed first layers and a worse filament flow during the printing of support beams.
I am unsure if others have this issue, but the issues are so apparent that I am downgrading to 01.06.01.00, which does not have these issues.