X1C print stop as if canceled, and error unknown code 03000D00-0002000A

[split]

@Kioto :thanks for your observations, flash pictures seem to highlight the various reflects on the plate

I went back to the printer and swapped for a different plate, and a 0.4 nozzle, before trying a printer auto test

the autotest failed with similar code 0300 4000 174717

and next attempt with a slightly different code 0300 4000 174817

full calibration failed too, but with more informative error message about “referincing Z axis failure”

0300d00-020000a-162817

which isn’t forwarded to the HSM , “unknown error + code 03000d00-0002000a-180517”

the last part seems to follow our local time , so is not significant : I’ll edit the threa to remove it

While I was checking the printer Z axis motors, I noticed that one of the bearing (?) seems out of place on the right hand Z guide

compared to the left side

I’ll look in the wiki about refitting the part, it seems that’ll need to take the printer apart

edit (again) :
several other thread about such errors suggest to check the rear Z axis could be messed up by print residues

Homing Z axis failed. [0300 4000 093824]

I’m new to this forum, with the printer (P1S) arriving only yesterday. That said, I received an error, related to the Z-Axis as well, and I discovered that I had installed the plate so that the rear of the plate was extending past the end of the bed, which caused the rear of the plate to lift a couple of mm. This was enough to cause the Z-Axis error. But, as was the case with others, clearing the problem did not clear the error. I had to recycle power to get the machine to reassess the statu…

I’ll check the easy ones first