X1C stopping after first layer

After my first layer which looks good the X1C stops, none of the interfaces say that it’s going into inspection and it never starts again or has an error… it just stops.

Without an error or anything, I’m not sure how to troubleshoot it. I end up having to cancel it and I get the normal cancel prints cannot be resumed message.

Does the lidar scan take place or does it stop before the lidar scan?

I’ve had this before with my other printers and it was the gcode

Is it just this particular gcode or does it do this with every attempted print ?

It was every model that I sent the printer from Bambu Studio… I power cycled the printer and the same stl is now working.

Maybe just power cycling worked.

I am using a Wham PEX sheet so I get errors with the Lidar and have the flow cal turned off. Not sure if there is a lidar after layer 1.

If you go to Bambu Studio, under the device tab, you will find a button Print Options. You can check/uncheck first layer inspection there.

But if a power cycle fixed it, great!