X1C won't start anymore

Bambu Lab X1 Series Troubleshooting
1

Hi everyone,

I’m turning to you because I have a problem.

Yesterday after a successful print, my X1c decided to give no sign of life. I tried the classic turn ON/OFF the rear switch, but when I do that, the fans spin for 2 seconds and then shut down, same thing for the bambu lab logo (see video).

Also the screen won’t display anything

My X1C has 200 hours of operation ±.

Do you have any idea what I can do?

Video link : https://youtube.com/shorts/Q8F3d-XdC8w?si=pPMoRjNkle3-XU8N

2

First, try removing the SD card if you have one installed and see if that is the issue.

Then follow the wiki for “No Power”

https://wiki.bambulab.com/en/x1/troubleshooting/circuit-board-power-failure

1 Like