Okay I am having the worst trouble with my X2D printer, it is only 3 weeks old and ever since I got it i’ve just had problems with it, warping always even with bambulabs super tack build plate, i have P1S also so the X2D is my second printer, i also have the super tack on my P1S and it prints waaaaaay better than my X2D the adhesion i crazy good on my P1S with the super tack, but on my X2D it’s always warping or not sticking to the plate, i have washed it with soap and warm water, done all the calibrations over and over, done manual bed leveling, but i just can’t get a decent looking print without it warping or having som layer shift like on the print, i have slowed down the first layer, and slowed down on walls, but still nothing changes. I have started a support ticket with bambulab asking if i can return the printer and replace it with 2 P1S combos and paying the differnce, you guys are sort of my last resort of trying to trouble shoot it. I have also read tons of threads here on this forum with guys having the same problems but haven’t found a solution to the problem.







