Hi everyone.
A little story:
*I am a P1S user for over a year with zero issue and last week I purchased an A1 after reading and watching the reviews/comments about it where almost 100% of the time the conclusion is “if you are printing mainly with PLA/PETG, then A1 is way to go…”
Apparently they do not work identical.
1st ISSUE:
The first 3 from left printed on A1 vs. 4th one on the far right is printed on P1S
On the A1, the printer throws of the object of off the print bed at where you see on the photo.
Does anyone have any idea as to why this might be happening?
- Printer: A1
- Settings: Default A1 0.4 Nozzle
- Filament: Bambulab Basic PLA
- faucet-extender.3mf (156.9 KB)
2nd ISSUE:
The image below is from a an ongoing print on P1S:
- This model is printed on 2 different P1S’s over and over again without any issue.
On the contrary this is from A1 which I had to stop during printing:
- Printer: A1
- Settings: Default A1 0.4 Nozzle
- Filament: Polymaker Polyterra PLA
-
If the warping is the issue, then why they failed on different levels?
-
And this 4cm diameter small sphere is also failed:
I have another A1 which I haven’t unboxed yet after experiencing the first issue.
I am going in between returning back those guys or not.
Any idea would be super helpful.
Thank you.