Hi all,
New to 3D printing, using A1 with AMS. I was also having issues with
parts getting knocked over. After some trial and error, and following the
many suggestions from helpful folks, I was able to print
a fairly complex item with lots of overhangs. I cleaned the plate with dish soap
(was using alcohol). Printed at normal speed, basic PLA, .04 nozzle, 0.12
high quality. I used the following settings:
The above increased the print time quite a bit, but I was happy
to get a clean part. It makes me wonder about the Bambu Studio
default settings though. I may try Gyroid in the next print as
sugested in an earlier post. Anyway, still learning!
Cheers…