AMS Custom Filaments

[pavlo]

Trying to redirect to where I added full instructions here. But unless i pad out this post I will reject due to being too similar.

[HOW TO] Add custom filaments so you can select them in the AMS

I believe there are some BBl instructions for this, but recent I was able to add my own filaments such that they can be selected from the touchscreen on the X1C, selectable in Bambu Slicer, and ultimately can be synced into the slicer without being limited to only the defaults and their settings. I have posted this in a couple of other threads, but just though it should have it’s own so I can edit one set of instructions. These do require a bit of fixing up, and will add each step as I did it,…