Hi all,
I have an X1C with the AMS and running the latest firmware on both. I have started to notice that one of my AMS slots (Slot #2) is having a hard time both sending filament and rewinding the filament for this particular slot. No other slot is having this issue. I will say that I only use SunLu filament (PETG, ASA, PLA, PLA+ and occasionally a roll of Bambu Carbon Fiber deigned for the AMS). I have noticed this with full rolls as well as when the roll gets about 3/4 empty. Note that I only use plastic spools that the SunLu filament comes on so I do not re-spool at all. Could it be that I have a weak/bad AMS Feeder Unit for this slot? Note that I never use any cardboard reels and the unit is clean inside and out. Again, it’s like the filament reel is slipping on the rubber rollers and I need to assist it when it’s trying to rewind the filament.
Any help would be appreciated.