On to the glacier
Works well with PLA, but I can not go any lower than 45C or I have occasional adhesion issues.
The recommendations for ABS / ASA are to use manufacturer recommended settings for the bed. Not only did this cause problems with part removal, it left discoloration on the bed from the red ABS I used. And the discoloration will not come off.
Will try a temp of 10C below the recommendations and see what happens.
Bambu AMS for TPU was difficult to get off at the recommended settings too.
This plate appears, at least to me, to have better adhesion for engineering filaments than what they claim. Will get back to you with more info after I do more prints. Have some regular TPU and more ABS and ASA prints coming up.
And like the Frostbite, wash before the first use.