Hi all Hope this is the right place for this post. New to printing, after 300hrs of successful PLA and PETG prints with no issues, I tried my first ASA print and ran into trouble. Freshly opened ASA filament pack Dried at 65° for 5hrs (highest temp my dryer goes) Loaded into AMS on P1S, stock 0…

You should always add a Brim with ASA…6-10 lines at least…or it will warp. Also, turning off the cooling fan helps. If BS saw it as ASA, then the fan was probably already set to off or a very low speed.

How are you cleaning your bed? Also here is a thread with some good ASA/ABS tips. [image] Printing ABS on PEI Plate Best Practices Bambu Lab X1C This is what works for me. Ideally you want the chamber temp as warm as possible. This is how I “preheat” the chamber. Turn…

Thank you I will give that a try. The Others>brim type dialogue was set to auto I assumed it would add it if needed It has also been suggested: Clean and apply a light layer of glue stick to the plate Slow first layer to 15-20 mm/s Is that under: Global>Speed>Initial Layer Slightly squ…

If you’re print with Bambu filament, the stock profile shouldn’t need tweaking if you have a clean enough bed. Dish soap and hot water. Really scrub at it with a clean brush and pat dry with a paper towel. I add a brim with zero “object-brim gap” for long parts or ones with a high wall count. You w…

If the print comes off are you added a Brim, you will have to use Glue.

Filaments that require an enclosure (ASA, ABS, PA, PC, etc) generally also require pre-heating the closed chamber. Manually set the bed temperature to at least 100°C, and run the auxiliary fan to circulate the air. Wait for chamber temperature of at least 45°C and then wait at least ten minutes mor…

Try to decrease the infill, same quantity of bottom and top layers, try to increase the Chamber temps up to 50 deg. A perfect first layer is necessary If you have edges, use brim ears ASA and ABS don’t need to dry, saves energy

No matter what I do, I have to use glue with ASA.

Thank you Yes i only have printed with Bambu brand filament I had recently cleaned the plate by wiping with IPA but not immediately prior to this run. I am always careful when reminding parts to not touch the plate or use tools to remove parts. I will give it a good wash regardless. Thanks

Thank you Where are the menu options to accomplish this? Are they in Bambu studio or on the P1S LCD?

ASA print fail

Bambu Filament and Accesories Filament

JonRaymond August 10, 2025, 6:03pm 3

How are you cleaning your bed?

Also here is a thread with some good ASA/ABS tips.