Bambulab P1S Enclosure temp

[Eponymous]

@mark_hahn

@PrintModz

With PLA, open the door and the lid,

If the upgrade includes the P1S cabinet fan then you don’t need to open the door. The purpose of the fan is to control the temperature. You can set the temp from 1 to 5, whatever that means.

Edit: The 1-5 setting thing is apparently wrong. In the filament setings you can specify the chamber temperature directly in degrees centigrade. It must have a sensor with a feedback loop.

Are you sure on that? The bambu instructions for the P1S and X1C both say open the door (EDIT actually the lid) with PLA on a hotplate (but not a cold plate)