i had a catastrophic build failure on my X1E (caused by lack of adhesion on cool plate, i have another concern about that) that wasnt detected and i was surprised. Spaghetti detection works fine but this failure isnt detected.
Has anyone had this sort of thing detected by their printer? it has caused me concern for future prints.
Yes, it’s to other people before:
Replacement for apparent X1E TH board failure? - Bambu Lab X1 Series / Troubleshooting - Bambu Lab Community Forum
thanks, useful thread. they don’t mention error detection either. so it seems blobs of doom aren’t detected then
Ive had it detected on a A1 , which i think actually made it worse by pushing the filament up the nozzle , with its detection system
hmm, it’s all getting a bit worrying. there are actually slice files out there that are dangerous to my printer’s health 
I dont know enough about gcode to reply to that ,other than i have noticed flow rates appear to of been added, on a files initial load ( changes )
1 Like