Hi All,
I have been away for a few months, so I am a bit behind on current affairs with BS, so apologies if this has already been covered.
I recall a few months back that Bambu decided to start locking down their firmware so that the printers (in future) would only be accessible via Bambu Studio (which would block Orca Slicer) and what not. This caused huge backlash from the community. As I was taking a hiatus from printing, I didn’t pay much attention to it at the time. Can anyone tell me the current state and stance from BL? Did they back down, or is this now enforced in the software?
Thanks,