Dimensionally Inaccurate Parts Being Produced by X1C

[JonRaymond]

Have you see this post about the skew compensation built into Bambu firmware?

Bambu Lab X1 Specific G-Code

XY Skew Compensation in Bambu Firmware Y ^ B-------C | / / | / / | A-------D +-------------->X XY SKEW FACTOR M1005 X<AC> Y<BD> (1) e.g. you print a 100mm square and measure AC as 141.53 and BD as 141.31 (2) using these values add this gcode to the end of the Machine start G-code: M1005 X141.53 Y141.31 M500 (M500 will save the compensation factor to EEPROM) (3) Print the square again and measure the diagonals. (4) If ok delete the gcode from the Machine start …