They really need to add the ability to turn off all of the LED’s when the printer is in standby mode. Or at least give people an option to keep it on or off.
2 Likes
I’d like the option of switching the lights/LED’s, including hot end, off at any time. If the door has a sensor, It would be great if the lights came back on when the door opens/closes then reopens if you leave the door open whilst printing PLA. Hope this comes to fruition!
2 Likes
The X1C does have a sensor switch for the door, but idk what it does in terms of printer control or messages. granted i am still quite new to the platform
If my X1C chamber light is off, it stays off until I start a print, goes off again after the print finishes.
All fans stop a short time after print completion.
The X1Plus firmware provides toolhead LED control.
The only LEDs that are always on are for the various controller boards. I can only see reflected light from the red one on the back of the toolhead.
2 Likes
It sure would be nice to have this in the standard firmware!
Hi
I’m running a P1S and also Home Assistant.
Are you aware of any resources where I could read up more on the ability to check or control different aspects of the P1S from Home Assistant?
Best regards from Europe