I am going to check my IP address like the comment above my initial post. But on another note, on the two prints I have attempted the filament has required me to manual pull it out front the back tube as it couldn’t retract back into the AMS…. okay I did that. After the second time, it kept giving me this error,
“Please pull out the filament on the spool holder. If this message persists, please check to see if there is filament broken in the extruder.
(Connect PTFE tube if you are about to use AMS)”
I have taken all filament out and reloaded it, as well as taken the entire extruder apart and changed the hotend to be safe. But I am still getting the same error and it refuses to print at all now.