How to smooth curved surface?

[EnoTheThracian]

Adaptive layer height appears at the top in the toolbar.

Variable Layer Height

It gives you quite a convenient tool to trade quality versus print time. However, it uses minimum threshold that, in my view, are outdated and based on thin air.
If the minimum layer height for a given nozzle is insufficient, you can hover the mouse over your printer at the top left to make the setting icon appear. In the Extruder settings, you can set your own threholds.
Just do not go below 0.03mm.
Flow control becomes really tricky below 0.02mm³/s.

&

Edit: Addendum:

Minimum Layer Height Limbo: How low can we go?

Introduction Why? As a hobbyist, “Because!” is enough of an answer for me :sweat_smile: . But there is indeed a bit more to it. A benchy to warm up As with all good “simple” questions, the original question did not lead me to an answer but to further questions: Was that a fluke? How good is a benchy for the minimum layer height question anyway? Did those flow issues come from the nominal layer height? Or was the infill combination to blame? Note: It defaults to a massive 100% nozzle diame…