I found here and in reddit that both the X1 and P1 series should use Idler Timing Pulley 20 Tooth Wheel Bore and a lot of the frequencies problems at high speed will be fixed but I haven’t found any information regarding why the printers doesn’t use them if they cost almost the same but by don’t doi…

Have a read through this long thread. [image] Banding / Ringing type artifacts? Bambu Lab X1-Carbon Hi all, been printing for about a year with Prusa so not a complete noob ( but not far away!! ). I have had my X1C Carbon for about 2 weeks and have printed about 40 hours…

yes to both, and regarding the second one is my main focus, this cause a lot of problems [image]

Idlers with Tooth

Bambu Lab X Series Bambu Lab X1C

JonRaymond April 19, 2024, 6:49pm 2

Have a read through this long thread.

Specifically starting at this post.