Layer Height Limit

[EnoTheThracian]

In fact, it is possible to set arbitrary limits in the slicer as part of the printers main settings. I did find that the true lower limit is given by minimum flow control.

Minimum Layer Height Limbo: How low can we go?

Introduction Why? As a hobbyist, “Because!” is enough of an answer for me :sweat_smile: . But there is indeed a bit more to it. A benchy to warm up As with all good “simple” questions, the original question did not lead me to an answer but to further questions: Was that a fluke? How good is a benchy for the minimum layer height question anyway? Did those flow issues come from the nominal layer height? Or was the infill combination to blame? Note: It defaults to a massive 100% nozzle diame…