Layer Shift

Hey, everybody.
I have a problem with layer offset on my P1S (firmware 01.05.01.00, mileage: 40 hours).
With all other models, no such problem is detected. Both before printing this model and after.

Who has any thoughts? XD I will be very grateful for any suggestions.

Project file: Dropbox


What you’re seeing here is the material shrinking when it it printing the inside top layer. The larger amount of plastic pulls the edges in as it cools. When the walls are printed on top of this they print in the original position which shows as a step because the part underneath of them has shrunk in.

1 Like

Is it possible to fight this?