Mid print layer shift - same layer every print

[JonRaymond]

This is not a layer shift. This is known as the “Benchy Hull Line” effect. There are lots of threads about it.

Beginner prints & quality concerns

It is not a shift. It has to do with the fact that the bottom is pretty solid and the walls are not. They contract and shrink differently due to cooling and that is what comes out as the lines around the bottom. The poor quality of the bottom where the support interfaces with the box is a result of the fact that the slicer is leaving some space between the top of the support and the first layer of the product. If the slicer would not do this the support would never come of the product. There ar…

Layer Shift

Hey, everybody. I have a problem with layer offset on my P1S (firmware 01.05.01.00, mileage: 40 hours). With all other models, no such problem is detected. Both before printing this model and after. Who has any thoughts? XD I will be very grateful for any suggestions. Project file: Dropbox [photo_2024-05-28_03-19-13] [photo_2024-05-28_03-19-12]