Hi. I have a new P2S/AMS Pro2 combo and it seems even with the filaments selected in Studio, they don’t sync to the machine and are not selectable. I have 2 X1Cs and 2 A1 combos and they all sync just fine. Is there a way to see my selected filaments on this new machine? Thanks a bunch!

[image] KetchupAndMayo: At the printer’s display and in BS I only get the options for Bambu and Generic. For the time being, there are NO other filament options for the P2S. I’ve contacted Polymaker and their reply was that they “might” release filament profiles “in the future". The P2S is a…

Bambu Lab Academy These courses should help you get started

Thanks, but those are of no help. I’ve had Bambu printers for a couple of years and don’t have this issue on the other 4 I have. The P2S is my newest and not like the others. Bambu and Generic are the only choices I have on it. My others have all of my filaments like Polymaker, eSun Sunlu, Overture …

Do you mean other manufacturers are missing from the firmware ? printer / filament / edit / filament ( only shows bambu and generic ?)

Correct. I have selected them all in Bambu Studio for my P2S. The printer is on the lastest firmware. At the printer’s display and in BS I only get the options for Bambu and Generic. Thanks again for any assistance :slight_smile:

If you have selected them here [image] Then they should show here in studio, ignore the left hand panel and select from the right hand side [image] [image] As for the printer there is usually a few other manufacturers here printer / filament / edit / filament , (A1 has 6 in total ), filamen…

[image] [image] The list of unsupported filaments for the p2s

Thanks for the info! Now I know why they don’t show up! Hopefully they release these for the P2S. For the couple days it’s been in service, it has worked quite well.

[image] P2S has only 2 filament options? Bambu Lab P2S I opened a Ticket for this and that was the response. [English translated by Copilot] Dear Customer, Thank you very much for your feedback. Regarding your question about why you cannot select filament f…

This is most frustrating. Creating your own profiles for filaments can be done, not easily, under the custom tab. When loading a filament you have to select Bambu or Generic on the printer, these are the only profiles on there (no custom profiles are able to be downloaded). Then open Studio and sync…

[image] spaceghost: If you could push these custom profiles to the printer you could select it there, and it would remember no matter how you log into studio (PC or iphone, etc). Since Bambu won’t create profiles they should at least allow your custom profiles to be downloaded to the printer for…

New P2S and filament sync?

Bambu Lab P Series Bambu Lab P2S

Neiljt February 5, 2026, 5:16pm 10

Perhaps this will help from customer support