Anyone having this issue? Had zero issues with the H2D until this started. I’ve replaced the nozzle wiper with new spares, but they keep getting knocked out of place during the wiping operations. Any ideas?
Yes I have had this issue just swap it out with the spare.
GeoffS
October 26, 2025, 1:01am
3
Had the same problem, check out this thread
Hi everyone — I wanted to share an important factory assembly issue I discovered with my new H2D printer that could lead to serious damage if not caught early. My printer was shipped with the Purge Wiper Assembly installed incorrectly from the factory, which caused the toolhead to become trapped during the purge and clean cycle — resulting in significant damage to the printer.
I did that already. Still no joy. Will look at it more closely tommorow and open a ticket😭