P1S stepper active noise cancellation?

Bambu Lab P1 Series General Discussions
1

Hi,

I switched from a P1P to a P1S and was quite surprised of the still very loud stepper motors in comparison to the P1P.

I did the initial calibration process, which took >20 min.

Is there no active noise cancellation for the stepper motors in the FW yet? And if so: is there an ETA?

Thanks.

BR Zappo

2

What firmware version is your P1S on?

3

Motor Noise Cancelling Calibration Issue ?

4

Hi Neiljt,

thank you very much, I thought this would happen, when I do the initial calibration.

I’ve started now the Motor Noice Cancelation in BambuStudio and will test again.

BR, Zappo

5

Hi JonRaymond,

it’s the 01.06.00.00.

BR, Zappo

6

P1 series OTA version01.05.00.00 (20240102)

may give you a better understanding of the process for your printer